terumo bct, ltd. - Medication Listings

ANTICOAGULANT CITRATE DEXTROSE SOLUTION USP (ACD) SOLUTION A is designed to be metered by an apheresis device in apheresis procedures, to prevent platelet activation and coagulation as blood moves throughout the extracorporeal unit (tubing set) in an apheresis procedure. The solution is sterile and non-pyrogenic, and it contains no bacteriostatic or antimicrobial agents. The formulas of the active ingredients are provided in Table 1. Table 1: Active Ingredients Ingredients Molecular Formula Molecular Weight (%w/v) Citric Acid, Monohydrate C 6 H 8 O 7 192.12 Dextrose Monohydrate C 6 H 12 O 6 ∙ H 2 O 198.17 Sodium Citrate Dihydrate C 6 H 9 Na 3 O 9 294.10 Water for Injection H 2 O 18.00 Each 100 mL of ANTICOAGULANT CITRATE DEXTROSE SOLUTION USP (ACD) SOLUTION A contains: (%w/v) Citric Acid, Monohydrate 0.8 g; Dextrose Monohydrate 2.45 g; Sodium Citrate Dihydrate 2.2 g; and Water for Injection. The polyolefin bag is not made with natural rubber latex or PVC. The bag is made from a multilayered film. It contains materials that have been tested to demonstrate the suitability of the container for storing pharmaceutical solutions. The solution contact layer is an elasticized polyolefin. The bag is nontoxic and biologically inert. The bag-solution unit is a closed system and is not dependent upon entry of external air during administration. The bag is overwrapped to provide protection from the physical environment and to provide an additional moisture barrier when necessary.

Sterile. Non-pyrogenic. Do not use unless the solution is clear and the container is intact. Rx Only. Single use container. For use only with apheresis devices. See apheresis device operator's manual for complete instructions.

ADDITIVE SOLUTION FORMULA 3 (AS-3) is designed to be added to packed RBC collected in apheresis procedures, and acts to preserve and extend the shelf life of packed RBC products for later transfusion to patients. The solution is intended to be metered by an apheresis device during apheresis procedures or added manually after a collection. Additive Solution Formula 3 (AS-3) is a clear solution that is steam-sterilized and non-pyrogenic. It does not contain bacteriostatic or antimicrobial agents. The formulas of the active ingredients are provided in Table 1. Table 1: Active Ingredients Ingredients Molecular Formula Molecular Weight Dextrose Monohydrate USP C 6 H 12 O 6 ∙ H 2 O 198.17 Trisodium Citrate Dihydrate USP C 6 H 9 Na 3 O 9 294.10 Sodium Chloride USP NaCl 58.44 Monobasic Sodium Phosphate Monohydrate USP NaH 2 PO 4 ∙ H 2 O 137.99 Citric Acid Monohydrate USP C 6 H 8 0 7 ∙ H 2 O 210.14 Adenine USP C 5 H 5 N 5 135.13 Water for Injection USP H 2 O 18.00 Each 100 mL of ADDITIVE SOLUTION FORMULA 3 (AS-3) contains: Dextrose Monohydrate USP 1.10 g; Trisodium Citrate Dihydrate USP 0.59 g; Sodium Chloride USP 0.41 g; Monobasic Sodium Phosphate Monohydrate USP 0.28 g; Citric Acid Monohydrate USP 0.042 g; Adenine USP 0.03 g; and Water for Injection USP. ADDITIVE SOLUTION FORMULA 3 is available in three volumes: 100 mL, 200 mL and 350 mL. The 100 mL bags are individually wrapped with a clear plastic film. Six individually wrapped bags are then vacuum-sealed in a foil pouch, which serves as a vapor barrier to prevent water loss during storage. After you remove the individual solution bags from the foil pouch, you can either leave them in the clear plastic film or remove and discard it. Once the foil pouch has been opened, use all six of the solution bags within 2 weeks. The 200 mL and 350 mL bags are individually wrapped with a clear plastic film. These larger volumes do not require the additional vapor barrier. Once the clear plastic film has been removed, use the solution within 2 weeks. The Polyolefin bag is not made with natural rubber latex. The bag is made from a multilayered film. It contains materials that have been tested to demonstrate the suitability of the container for storing pharmaceutical solutions. The bag is nontoxic and biologically inert. The bag-solution unit is a closed system and is not dependent upon entry of external air during administration.

ANTICOAGULANT CITRATE DEXTROSE SOLUTION USP (ACD) SOLUTION A is designed to be added to blood products collected for extracorporeal processing, to prevent platelet activation and coagulation as blood moves throughout the extracorporeal processing set. The content of the solution bag is considered sterile. This product has a sterile fluid path only. The clear overwrap is not considered a sterile barrier. The solution is non-pyrogenic, and it contains no bacteriostatic or antimicrobial agents. The formulas of the active ingredients are provided in Table 1. Table 1: Active Ingredients Ingredients Molecular Formula Molecular Weight (%w/v) Citric Acid, Monohydrate C 6 H 8 O 7 192.12 Dextrose Monohydrate C 6 H 12 O 6 ∙ H 2 O 198.17 Sodium Citrate Dihydrate C 6 H 9 Na 3 O 9 294.10 Water for Injection H 2 O 18.00 Each 100 mL of ANTICOAGULANT CITRATE DEXTROSE SOLUTION USP (ACD) SOLUTION A contains: (%w/v) Citric Acid, Monohydrate 0.8 g; Dextrose Monohydrate 2.45 g; Sodium Citrate Dihydrate 2.2 g; and Water for Injection. The solution bag is not made with natural rubber latex or PVC. The solution bag is made from a polyolefin film. It contains materials that have been tested to demonstrate the suitability of the solution bag for storing pharmaceutical solutions. The solution contact layer is a polyolefin. The solution bag is nontoxic and biologically inert. The solution bag is a closed system and is not dependent upon entry of external air during administration. The solution bag is covered with a clear overwrap to provide protection from the physical environment. The content of the solution bag is considered sterile. This product has a sterile fluid path only. The clear overwrap is not considered a sterile barrier.

SODIUM CITRATE 4% W/V ANTICOAGULANT SOLUTION USP is designed to be metered by an apheresis device in apheresis procedures, to prevent platelet activation and coagulation as blood moves throughout the extracorporeal unit (tubing set) in an apheresis procedure. The solution is sterile and non-pyrogenic, and it contains no bacteriostatic or antimicrobial agents. The formulas of the active ingredients are provided in Table 1. Table 1: Active Ingredients Ingredients Molecular Formula Molecular Weight Sodium Citrate Dihydrate C 6 H 9 Na 3 O 9 294.10 Water for Injection H 2 O 18.00 Each 100 mL of SODIUM CITRATE 4% W/V ANTICOAGULANT SOLUTION USP contains: Sodium Citrate (dihydrate) 4.0 g; and 100mL Water for Injection (pH adjusted with citric acid). The PVC bag is not made with natural rubber latex. The bag is made from a multilayered film. It contains materials that have been tested to demonstrate the suitability of the container for storing pharmaceutical solutions. The bag is nontoxic and biologically inert. The bag-solution unit is a closed system and is not dependent upon entry of external air during administration. The bag is overwrapped to provide protection from the physical environment and to provide an additional moisture barrier when necessary.

SODIUM CITRATE 4% W/V ANTICOAGULANT SOLUTION USP is designed to be metered by an apheresis device in apheresis procedures, to prevent platelet activation and coagulation as blood moves throughout the extracorporeal unit (tubing set) in an apheresis procedure. The solution is sterile and non-pyrogenic, and it contains no bacteriostatic or antimicrobial agents. Sterilized with steam. The formulas of the active ingredients are provided in Table 1. Table 1: Active Ingredients Ingredients Molecular Formula Molecular Weight Sodium Citrate Dihydrate C 6 H 9 Na 3 O 9 294.10 Water for Injection H 2 O 18.00 Each 100 mL of SODIUM CITRATE 4% W/V ANTICOAGULANT SOLUTION USP contains: Sodium Citrate (dihydrate) 4.0 g; and Water for Injection to 100 mL (pH adjusted with citric acid). Approximate millimoles of sodium citrate: 13.8. The polyolefin bag is not made with natural rubber latex. The bag contains materials that have been tested to demonstrate the suitability of the container for storing pharmaceutical solutions. The bag is nontoxic and biologically inert. The bag-solution unit is a closed system and is not dependent upon entry of external air during administration. The bag is overwrapped to provide protection from the physical environment and to provide an additional moisture barrier when necessary.