sodium chloride sodium gluconate sodium acetate potassium chloride and magnesium chloride - Generic Medications

Each 100 mL of Isolyte ® S (Multi-Electrolyte Injection) contains: Sodium Chloride USP 0.53 g; Sodium Gluconate USP 0.5 g Sodium Acetate Trihydrate USP 0.37 g; Potassium Chloride USP 0.037 g Magnesium Chloride Hexahydrate USP 0.03 g Water for Injection USP qs pH adjusted with Glacial Acetic Acid USP pH: 6.7 (6.3–7.3) Calculated Osmolarity: 295 mOsmol/liter Concentration of Electrolytes (mEq/liter): Sodium 140; Potassium 5 Magnesium 3; Chloride 98; Acetate (CH 3 COO − ) 27 Gluconate (HOCH 2 (CHOH) 4 COO − ) 23 Isolyte ® S is sterile, nonpyrogenic, and contains no bacteriostatic or antimicrobial agents. The formulas of the active ingredients are: Ingredients Molecular Formula Molecular Weight Sodium Chloride USP NaCl 58.44 Sodium Acetate Trihydrate USP CH 3 COONa•3H 2 O 136.08 Potassium Chloride USP KCl 74.55 Magnesium Chloride Hexahydrate USP MgCl 2 •6H 2 O 203.30 Sodium Gluconate USP 218.14 Not made with natural rubber latex, PVC or DEHP. The plastic container is made from a multilayered film specifically developed for parenteral drugs. It contains no plasticizers and exhibits virtually no leachables. The solution contact layer is a rubberized copolymer of ethylene and propylene. The container is nontoxic and biologically inert. The container-solution unit is a closed system and is not dependent upon entry of external air during administration. The container is overwrapped to provide protection from the physical environment and to provide an additional moisture barrier when necessary. Addition of medication should be accomplished using complete aseptic technique. The closure system has two ports; the one for the administration set has a tamper evident plastic protector and the other is a medication addition site. Refer to the Directions for Use of the container. structural formula

Multiple Electrolytes Injection, Type 1, USP, pH 5.5 is a sterile, nonpyrogenic isotonic solution in a single dose container for intravenous administration. Each 100 mL contains 526 mg of Sodium Chloride, USP (NaCl); 502 mg of Sodium Gluconate (C 6 H 11 NaO 7 ); 368 mg of Sodium Acetate Trihydrate, USP (C 2 H 3 NaO 2 •3H 2 O); 37 mg of Potassium Chloride, USP (KCl); and 30 mg of Magnesium Chloride, USP (MgCl 2 •6H 2 O). It contains no antimicrobial agents. The pH is adjusted with hydrochloric acid. The pH is 5.5 (4.0 to 8.0). Multiple Electrolytes Injection, Type 1, USP, pH 5.5 administered intravenously has value as a source of water, electrolytes, and calories. One liter has an ionic concentration of 140 mEq sodium, 5 mEq potassium, 3 mEq magnesium, 98 mEq chloride, 27 mEq acetate, and 23 mEq gluconate. The osmolarity is 294 mOsmol/L (calc). Normal physiologic osmolarity range is approximately 280 to 310 mOsmol/L. The caloric content is 21 kcal/L. The flexible plastic container is fabricated from a specially formulated non-plasticized, film containing polypropylene and thermoplastic elastomers ( free flex ® bag). The amount of water that can permeate from inside the container into the overwrap is insufficient to affect the solution significantly. Solutions in contact with the plastic container can leach out certain of its chemical components in very small amounts within the expiration period. However, the safety of the plastic has been confirmed in tests in animals according to USP biological tests for plastic containers as well as by tissue culture toxicity studies.

Multiple Electrolytes Injection, Type 1, USP, pH 7.4 is a sterile, nonpyrogenic isotonic solution in a single dose container for intravenous administration. Each 100 mL contains 526 mg of Sodium Chloride, USP (NaCl); 502 mg of Sodium Gluconate (C 6 H 11 NaO 7 ); 368 mg of Sodium Acetate Trihydrate, USP (C 2 H 3 NaO 2 •3H 2 O); 37 mg of Potassium Chloride, USP (KCl); and 30 mg of Magnesium Chloride, USP (MgCl 2 •6H 2 O). It contains no antimicrobial agents. The pH is adjusted with sodium hydroxide. The pH is 7.4 (6.5 to 8.0). Multiple Electrolytes Injection, Type 1, USP, pH 7.4 administered intravenously has value as a source of water, electrolytes, and calories. One liter has an ionic concentration of 140 mEq sodium, 5 mEq potassium, 3 mEq magnesium, 98 mEq chloride, 27 mEq acetate, and 23 mEq gluconate. The osmolarity is 294 mOsmol/L (calc). Normal physiologic osmolarity range is 280 to 310 mOsmol/L. The caloric content is 21 kcal/L. The flexible plastic container is fabricated from a specially formulated non-plasticized, film containing polypropylene and thermoplastic elastomers ( free flex ® bag). The amount of water that can permeate from inside the container into the overwrap is insufficient to affect the solution significantly. Solutions in contact with the plastic container can leach out certain of its chemical components in very small amounts within the expiration period. However, the safety of the plastic has been confirmed in tests in animals according to USP biological tests for plastic containers as well as by tissue culture toxicity studies.

Physiolyte is a sterile, nonpyrogenic solution of electrolytes in water for injection intended only for sterile irrigation, washing, and rinsing purposes. Each 100 mL contains: Sodium Chloride USP 0.53 g; Sodium Gluconate USP 0.5 g Sodium Acetate Trihydrate USP 0.37 g; Potassium Chloride USP 0.037 g; Magnesium Chloride Hexahydrate USP 0.03 g Water for Injection USP qs Glacial Acetic Acid USP has been added to adjust the pH pH: 6.8 (6.3–7.3) Calculated Osmolarity: The solution is isotonic (295 mOsmol/liter) Concentration of Electrolytes (mEq/liter): Sodium 140 Potassium 5; Magnesium 3; Chloride 98; Acetate (CH 3 COO − ) 27 Gluconate (HOCH 2 (CHOH) 4 COO − ) 23 It contains no bacteriostat, antimicrobial agent or added buffer (except for pH adjustment) and is intended only for use as a single-dose or short procedure irrigation. When smaller volumes are required the unused portion should be discarded. Physiolyte may be classified as a sterile irrigant, wash, rinse and pharmaceutical vehicle. The formulas of the active ingredients are: Ingredients Molecular Formula Molecular Weight Sodium Chloride USP NaCl 58.44 Sodium Acetate Trihydrate USP CH 3 COONa•3H 2 O 136.08 Potassium Chloride USP KCl 74.55 Magnesium Chloride Hexahydrate USP MgCl 2 •6H 2 O 203.30 Sodium Gluconate USP 218.14 The plastic container is a copolymer of ethylene and propylene formulated and developed for parenteral drugs. The copolymer contains no plasticizers and exhibits virtually no leachability. The plastic container is also virtually impermeable to vapor transmission and therefore, requires no overwrap to maintain the proper drug concentration. The safety of the plastic container has been confirmed by biological evaluation procedures. The material passes Class VI testing as specified in the U.S. Pharmacopeia for Biological Tests. The safety of the plastic has been confirmed by tests in animals according to USP biological standards for plastic containers. Not made with natural rubber latex, PVC or DEHP. Chemical Structure

PLASMA-LYTE A Injection pH 7.4 (Multiple Electrolytes Injection, Type 1, USP) is a sterile, nonpyrogenic isotonic solution in a single dose container for intravenous administration. Each 100 mL contains 526 mg of Sodium Chloride, USP (NaCl); 502 mg of Sodium Gluconate (C 6 H 11 NaO 7 ); 368 mg of Sodium Acetate Trihydrate, USP (C 2 H 3 NaO 2 •3H 2 O); 37 mg of Potassium Chloride, USP (KCl); and 30 mg of Magnesium Chloride, USP (MgCl 2 •6H 2 O). It contains no antimicrobial agents. The pH is adjusted with sodium hydroxide. The pH is 7.4 (6.5 to 8.0). PLASMA-LYTE A Injection pH 7.4 (Multiple Electrolytes Injection, Type 1, USP) administered intravenously has value as a source of water, electrolytes, and calories. One liter has an ionic concentration of 140 mEq sodium, 5 mEq potassium, 3 mEq magnesium, 98 mEq chloride, 27 mEq acetate, and 23 mEq gluconate. The osmolarity is 294 mOsmol/L (calc). Normal physiologic osmolarity range is 280 to 310 mOsmol/L. The caloric content is 21 kcal/L. The VIAFLEX plastic container is fabricated from a specially formulated polyvinyl chloride (PL 146 Plastic). The amount of water that can permeate from inside the container into the overwrap is insufficient to affect the solution significantly. Solutions in contact with the plastic container can leach out certain of its chemical components in very small amounts within the expiration period, e.g., di-2-ethylhexyl phthalate (DEHP), up to 5 parts per million. However, the safety of the plastic has been confirmed in tests in animals according to USP biological tests for plastic containers as well as by tissue culture toxicity studies.

Summary not available yet.