dextrose sodium chloride and potassium chloride - Generic Medications

(See chart below for quantitative information.) Potassium Chloride in Dextrose and Sodium Chloride Injections USP are sterile, nonpyrogenic and contain no bacteriostatic or antimicrobial agents. These products are intended for intravenous administration. The formulas of the active ingredients are: Ingredients Molecular Formula Molecular Weight Sodium Chloride USP Potassium Chloride USP NaCl KCl 58.44 74.55 Hydrous Dextrose USP 198.17 Not made with natural rubber latex, PVC or DEHP. The plastic container is made from a multilayered film specifically developed for parenteral drugs. It contains no plasticizers and exhibits virtually no leachables. The solution contact layer is a rubberized copolymer of ethylene and propylene. The container is nontoxic and biologically inert. The container-solution unit is a closed system and is not dependent upon entry of external air during administration. The container is overwrapped to provide protection from the physical environment and to provide an additional moisture barrier when necessary. Composition – Each 100 mL contains: Solution Hydrous Dextrose USP Sodium Chloride USP Potassium Chloride USP Concentration of Electrolytes (mEq/liter) Calories per liter Calculated Osmolarity mOsmol/liter pH Sodium Potassium Chloride Water for Injection USP qs 0.15% Potassium Chloride in 5% Dextrose and 0.20% Sodium Chloride Injection USP 5 g 0.2 g 0.15 g 34 20 54 170 360 4.4 (3.5–6.5) 0.075% Potassium Chloride in 5% Dextrose and 0.45% Sodium Chloride Injection USP 5 g 0.45 g 0.075 g 77 10 87 170 425 4.4 (3.5–6.5) 0.15% Potassium Chloride in 5% Dextrose and 0.45% Sodium Chloride Injection USP 5 g 0.45 g 0.15 g 77 20 97 170 445 4.4 (3.5–6.5) 0.22% Potassium Chloride in 5% Dextrose and 0.45% Sodium Chloride Injection USP 5 g 0.45 g 0.22 g 77 30 107 170 465 4.4 (3.5–6.5) 0.30% Potassium Chloride in 5% Dextrose and 0.45% Sodium Chloride Injection USP 5 g 0.45 g 0.3 g 77 40 117 170 490 4.4 (3.5–6.5) 0.15% Potassium Chloride in 5% Dextrose and 0.9% Sodium Chloride Injection USP 5 g 0.9 g 0.15 g 154 20 174 170 600 4.4 (3.5–6.5) Addition of medication should be accomplished using complete aseptic technique. The closure system has two ports; the one for the administration set has a tamper evident plastic protector and the other is a medication addition site. Refer to the Directions for Use of the container. Chemical Structure