SODIUM CITRATE 4% W/V ANTICOAGULANT

SODIUM CITRATE 4% W/V ANTICOAGULANT SOLUTION USP is designed to be metered by an apheresis device in apheresis procedures, to prevent platelet activation and coagulation as blood moves throughout the extracorporeal unit (tubing set) in an apheresis procedure. The solution is sterile and non-pyrogenic, and it contains no bacteriostatic or antimicrobial agents. The formulas of the active ingredients are provided in Table 1. Table 1: Active Ingredients Ingredients Molecular Formula Molecular Weight Sodium Citrate Dihydrate C 6 H 9 Na 3 O 9 294.10 Water for Injection H 2 O 18.00 Each 100 mL of SODIUM CITRATE 4% W/V ANTICOAGULANT SOLUTION USP contains: Sodium Citrate (dihydrate) 4.0 g; and 100mL Water for Injection (pH adjusted with citric acid). The PVC bag is not made with natural rubber latex. The bag is made from a multilayered film. It contains materials that have been tested to demonstrate the suitability of the container for storing pharmaceutical solutions. The bag is nontoxic and biologically inert. The bag-solution unit is a closed system and is not dependent upon entry of external air during administration. The bag is overwrapped to provide protection from the physical environment and to provide an additional moisture barrier when necessary.

SODIUM CITRATE 4% W/V ANTICOAGULANT SOLUTION is intended for use only for the anticoagulation of whole blood as part of automated apheresis procedures. [See Dosage and Administration (2) .] SODIUM CITRATE 4% W/V ANTICOAGULANT SOLUTION USP is intended for use only for the anticoagulation of whole blood as part of automated apheresis procedures. ( 1 )

SODIUM CITRATE 4% ANTICOAGULANT SOLUTION USP is added to tubing sets during apheresis procedures. ( 2 ) SODIUM CITRATE 4% ANTICOAGULANT SOLUTION USP may only be used with apheresis devices. For instructions on the use of the solution see the apheresis device operator's manual. ( 2.1 ) Follow the directions for connecting the SODIUM CITRATE 4% ANTICOAGULANT SOLUTION USP bag to the apheresis system. ( 2.2 ) 2.1 General Dosing Information SODIUM CITRATE 4% W/V ANTICOAGULANT SOLUTION USP is added to tubing sets during apheresis procedures. The solution is connected the tubing set in an apheresis collection. The recommended dose is determined by the apheresis device and metered into the tubing set by the apheresis device. It is not intended for direct intravenous infusion. For instructions on the use of the solution with the apheresis device and tubing set, see the device operator's manual. 2.2 Administration Ensure solution is the SODIUM CITRATE 4% W/V ANTICOAGULANT SOLUTION USP and is within the expiration date. Inspect the bag. Do not use if the container is damaged, leaking or if there is any visible sign of deterioration. Use only if solution is clear and free of particulate matter. Protect from sharp objects. Directions for connecting the SODIUM CITRATE 4% W/V ANTICOAGULANT SOLUTION USP bag to the apheresis device. At the prompt to connect anticoagulant to the apheresis device tubing set: Remove the overwrap by pulling down at the notch, and remove the SODIUM CITRATE 4% W/V ANTICOAGULANT SOLUTION USP bag. Before use, perform the following checks [See Warnings and Precautions (5) .] : Check for leaks by gently squeezing the bag. If leaks are found, discard the bag. Ensure that the solution is the SODIUM CITRATE 4% W/V ANTICOAGULANT SOLUTION USP and is within the expiration date. Inspect the solution in good light. Bags showing cloudiness, haze, or particulate matter should not be used. Remove the protective cap from the port on the bag. Connect the bag to the apheresis device tubing set using aseptic technique and hang the solution. Proceed according to the apheresis device operator's manual. Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration, whenever the solution and container permit.

DO NOT INFUSE SODIUM CITRATE 4% W/V ANTICOAGULANT SOLUTION USP DIRECTLY TO THE DONOR. DO NOT INFUSE SODIUM CITRATE 4% W/V ANTICOAGULANT SOLUTION USP DIRECTLY TO THE DONOR. ( 4 )

Citrate reactions or toxicity may occur with the infusion of blood products to patients and return of blood containing citrate anticoagulant to donors. The recipient of the blood containing citrate should be monitored for the signs and symptoms of citrate toxicity. The signs and symptoms of citrate toxicity begin with paresthesia, a "tingling" sensation around the mouth or in the extremities, followed by severe reactions that are characterized by hypotension and possible cardiac arrhythmia. Citrate toxicity may occur more frequently in patients who are hypothermic, have impaired liver or renal function, or have low calcium levels because of an underlying disease. Citrate reactions or toxicity may occur with the infusion and return of blood containing citrate anticoagulant. The recipient of the blood containing citrate should be monitored for the signs and symptoms of citrate toxicity. ( 6 ) To report SUSPECTED ADVERSE REACTIONS, contact Terumo BCT, Inc. at 1-877-339-4228 or FDA at 1-800-FDA-1088 or www.fda.gov/medwatch .

STORAGE Up to 25 °C. Protect from freezing.