Drugs Similar to LIDOCAINE HCI AND DEXTROSE

25% Dextrose Injection, USP is a sterile, nonpyrogenic, hypertonic solution of dextrose in water for injection administered by intravenous injection to restore blood glucose levels in hypoglycemia and as a source of carbohydrate calories. Each milliliter (mL) of fluid contains dextrose, hydrous, 250 mg which delivers 3.4 kcal/gram (0.85 kcal/mL). The solution has an osmolarity of 1.39 mOsmol/mL (calc.). pH is 4.5 (3.2 to 6.5). May contain hydrochloric acid and sodium hydroxide for pH adjustment. The solution contains no bacteriostat, antimicrobial agent or added buffer (except for pH adjustment) and is intended only for use as a single-dose injection. When smaller doses are required the unused portion should be discarded with the entire unit. 25% Dextrose Injection, USP is a dextrose (glucose) and nutrient (carbohydrate) replenisher. Dextrose, USP is chemically designated D-glucose monohydrate, (C6H12O6 • H2O), a hexose sugar freely soluble in water. It has the following structural formula: The syringe is molded from a specially formulated polypropylene. Water permeates from inside the container at an extremely slow rate which will have an insignificant effect on solution concentration over the expected shelf life. Solutions in contact with the plastic container may leach out certain chemical components from the plastic in very small amounts; however, biological testing was supportive of the safety of the syringe material. Dextrose Structure

50% Dextrose Injection, USP is a sterile, nonpyrogenic, hypertonic solution of dextrose in water for injection for intravenous injection as a fluid and nutrient replenisher. Each mL of fluid contains 0.5 g dextrose, hydrous which delivers 3.4 kcal/gram. The solution has an osmolarity of 2.53 mOsmol/mL (calc.), a pH of 4.2 (3.2 to 6.5) and may contain sodium hydroxide and/or hydrochloric acid for pH adjustment. The solution contains no bacteriostat, antimicrobial agent or added buffer (except for pH adjustment) and is intended only for use as a single-dose injection. When smaller doses are required, the unused portion should be discarded with the entire unit. Dextrose, USP is chemically designated C6H12O6 ∙ H2O (D-glucose monohydrate), a hexose sugar freely soluble in water. Dextrose, hydrous has the following structural formula: Water for Injection, USP is chemically designated H2O. The syringe is molded from a specially formulated polypropylene. Water permeates from inside the container at an extremely slow rate which will have an insignificant effect on solution concentration over the expected shelf life. Solutions in contact with the plastic container may leach out certain chemical components from the plastic in very small amounts; however, biological testing was supportive of the safety of the syringe material. STRUCTURE

ANTICOAGULANT CITRATE DEXTROSE SOLUTION USP (ACD) SOLUTION A is designed to be metered by an apheresis device in apheresis procedures, to prevent platelet activation and coagulation as blood moves throughout the extracorporeal unit (tubing set) in an apheresis procedure. The solution is sterile and non-pyrogenic, and it contains no bacteriostatic or antimicrobial agents. The formulas of the active ingredients are provided in Table 1. Table 1: Active Ingredients Ingredients Molecular Formula Molecular Weight (%w/v) Citric Acid, Monohydrate C 6 H 8 O 7 192.12 Dextrose Monohydrate C 6 H 12 O 6 ∙ H 2 O 198.17 Sodium Citrate Dihydrate C 6 H 9 Na 3 O 9 294.10 Water for Injection H 2 O 18.00 Each 100 mL of ANTICOAGULANT CITRATE DEXTROSE SOLUTION USP (ACD) SOLUTION A contains: (%w/v) Citric Acid, Monohydrate 0.8 g; Dextrose Monohydrate 2.45 g; Sodium Citrate Dihydrate 2.2 g; and Water for Injection. The polyolefin bag is not made with natural rubber latex or PVC. The bag is made from a multilayered film. It contains materials that have been tested to demonstrate the suitability of the container for storing pharmaceutical solutions. The solution contact layer is an elasticized polyolefin. The bag is nontoxic and biologically inert. The bag-solution unit is a closed system and is not dependent upon entry of external air during administration. The bag is overwrapped to provide protection from the physical environment and to provide an additional moisture barrier when necessary.

Sterile. Non-pyrogenic. Do not use unless the solution is clear and the container is intact. Rx Only. Single use container. For use only with apheresis devices. See apheresis device operator's manual for complete instructions.

Summary not available yet.

Summary not available yet.

Summary not available yet.

ADDITIVE SOLUTION FORMULA 3 (AS-3) is designed to be added to packed RBC collected in apheresis procedures, and acts to preserve and extend the shelf life of packed RBC products for later transfusion to patients. The solution is intended to be metered by an apheresis device during apheresis procedures or added manually after a collection. Additive Solution Formula 3 (AS-3) is a clear solution that is steam-sterilized and non-pyrogenic. It does not contain bacteriostatic or antimicrobial agents. The formulas of the active ingredients are provided in Table 1. Table 1: Active Ingredients Ingredients Molecular Formula Molecular Weight Dextrose Monohydrate USP C 6 H 12 O 6 ∙ H 2 O 198.17 Trisodium Citrate Dihydrate USP C 6 H 9 Na 3 O 9 294.10 Sodium Chloride USP NaCl 58.44 Monobasic Sodium Phosphate Monohydrate USP NaH 2 PO 4 ∙ H 2 O 137.99 Citric Acid Monohydrate USP C 6 H 8 0 7 ∙ H 2 O 210.14 Adenine USP C 5 H 5 N 5 135.13 Water for Injection USP H 2 O 18.00 Each 100 mL of ADDITIVE SOLUTION FORMULA 3 (AS-3) contains: Dextrose Monohydrate USP 1.10 g; Trisodium Citrate Dihydrate USP 0.59 g; Sodium Chloride USP 0.41 g; Monobasic Sodium Phosphate Monohydrate USP 0.28 g; Citric Acid Monohydrate USP 0.042 g; Adenine USP 0.03 g; and Water for Injection USP. ADDITIVE SOLUTION FORMULA 3 is available in three volumes: 100 mL, 200 mL and 350 mL. The 100 mL bags are individually wrapped with a clear plastic film. Six individually wrapped bags are then vacuum-sealed in a foil pouch, which serves as a vapor barrier to prevent water loss during storage. After you remove the individual solution bags from the foil pouch, you can either leave them in the clear plastic film or remove and discard it. Once the foil pouch has been opened, use all six of the solution bags within 2 weeks. The 200 mL and 350 mL bags are individually wrapped with a clear plastic film. These larger volumes do not require the additional vapor barrier. Once the clear plastic film has been removed, use the solution within 2 weeks. The Polyolefin bag is not made with natural rubber latex. The bag is made from a multilayered film. It contains materials that have been tested to demonstrate the suitability of the container for storing pharmaceutical solutions. The bag is nontoxic and biologically inert. The bag-solution unit is a closed system and is not dependent upon entry of external air during administration.

Uses For the temporary relief of pain due to minor burns, sunburns, minor cuts, scrapes, or minor skin irritations

AKTEN (lidocaine hydrochloride ophthalmic gel) 3.5% contains lidocaine hydrochloride, an amide local anesthetic, as a sterile ophthalmic gel for topical ophthalmic use. AKTEN does not contain an anti-microbial preservative. Lidocaine hydrochloride is designated chemically as acetamide, 2-(diethylamino)-N-(2,6-dimethylphenyl) monohydrochloride with a molecular formula of C 14 H 22 N 2 O ∙ HCl and molecular weight of 270.8. The structural formula of the active ingredient is: Each mL of AKTEN contains 35 mg of lidocaine hydrochloride as the active ingredient. Inactive ingredients: hypromellose, sodium chloride, and water for injection. The pH may be adjusted to 5.5 to 7.5 with hydrochloric acid and/or sodium hydroxide. AKTEN does not contain an anti-microbial preservative. Chemical Structure

Anticoagulant Citrate Dextrose Solution, Solution A, U.S.P., (ACD-A), is a sterile, non-pyrogenic solution of citric acid, sodium citrate, and dextrose, in water for injection. Each 10 mL of solution contains: Citric Acid, anhydrous, USP 0.073 g Sodium Citrate, dihydrate, USP 0.220 g Dextrose, monohydrate, USP 0.245 g Water for Injection, USP q.s. pH: 4.5 – 5.5 Single patient use only, on a single occasion. single use

Each 10mL contains Citric Acid Monohydrate USP 0.08 g Sodium Citrate Dihydrate USP 0.220 g Dextrose Monohydrate USP 0.245 g In Water for Injection USP

ANTICOAGULANT CITRATE DEXTROSE SOLUTION USP (ACD) SOLUTION A is designed to be added to blood products collected for extracorporeal processing, to prevent platelet activation and coagulation as blood moves throughout the extracorporeal processing set. The content of the solution bag is considered sterile. This product has a sterile fluid path only. The clear overwrap is not considered a sterile barrier. The solution is non-pyrogenic, and it contains no bacteriostatic or antimicrobial agents. The formulas of the active ingredients are provided in Table 1. Table 1: Active Ingredients Ingredients Molecular Formula Molecular Weight (%w/v) Citric Acid, Monohydrate C 6 H 8 O 7 192.12 Dextrose Monohydrate C 6 H 12 O 6 ∙ H 2 O 198.17 Sodium Citrate Dihydrate C 6 H 9 Na 3 O 9 294.10 Water for Injection H 2 O 18.00 Each 100 mL of ANTICOAGULANT CITRATE DEXTROSE SOLUTION USP (ACD) SOLUTION A contains: (%w/v) Citric Acid, Monohydrate 0.8 g; Dextrose Monohydrate 2.45 g; Sodium Citrate Dihydrate 2.2 g; and Water for Injection. The solution bag is not made with natural rubber latex or PVC. The solution bag is made from a polyolefin film. It contains materials that have been tested to demonstrate the suitability of the solution bag for storing pharmaceutical solutions. The solution contact layer is a polyolefin. The solution bag is nontoxic and biologically inert. The solution bag is a closed system and is not dependent upon entry of external air during administration. The solution bag is covered with a clear overwrap to provide protection from the physical environment. The content of the solution bag is considered sterile. This product has a sterile fluid path only. The clear overwrap is not considered a sterile barrier.

Summary not available yet.

Summary not available yet.

USES: • For the temporary relief of symptoms including: • headache • dizziness • mood changes • vomiting • nausea • abdominal cramps • abdominal pain • fatigue • weakness These statements are based upon homeopathic principles. They have not been reviewed by the Food and Drug Administration.

Uses Temporary relief of pain associated with minor cuts, scrapes, and burns. Helps protect against harmful bacteria.

Summary not available yet.

Summary not available yet.

Summary not available yet.