SODIUM CHLORIDE

0.9% Sodium Chloride Injection, USP is sterile and nonpyrogenic. It is a parenteral solution containing 0.9% sodium chloride in water for injection intended for intravenous administration. Each 100 mL of 0.9% Sodium Chloride Injection, USP contains 900 mg sodium chloride in water for injection. Electrolytes per 1000 mL: sodium 154 mEq; chloride 154 mEq. The osmolarity is 308 mOsmol/L (calc.). The pH is 5.6. The pH range is 4.5 - 7.0. The solution contains no bacteriostat, antimicrobial agent or added buffer and is intended only as a single-dose injection. When smaller doses are required the unused portion should be discarded. The solution is a parenteral fluid and electrolyte replenisher. Sodium Chloride, USP is chemically designated NaCl, a white crystalline powder freely soluble in water. Water for Injection, USP is chemically designed H 2 O. The flexible plastic container is fabricated from a specially formulated polyvinylchloride. Water can permeate from inside the container into the overwrap but not in amounts sufficient to affect the solution significantly. Solutions in contact with the plastic container may leach out certain chemical components from the plastic in very small amounts; however, biological testing was supportive of the safety of the plastic container materials. Exposure to temperatures above 25°C (77°F) during transport and storage will lead to minor losses in moisture content. Higher temperatures lead to greater losses. It is unlikely that these minor losses will lead to clinically significant changes within the expiration period.

Intravenous solutions containing sodium chloride are indicated for parenteral replenishment of fluid and sodium chloride as required by the clinical condition of the patient.

The dose is dependent upon the age, weight and clinical condition of the patient. Additives may be incompatible. Consult with pharmacist, if available. When introducing additives, use aseptic technique, mix thoroughly and do not store. Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration, whenever solution and container permit. (See PRECAUTIONS .) INSTRUCTIONS FOR USE To Open Tear outer wrap at notch and remove solution container. If supplemental medication is desired, follow directions below before preparing for administration. Some opacity of the plastic due to moisture absorption during the sterilization process may be observed. This is normal and does not affect the solution quality or safety. The opacity will diminish gradually. To Add Medication Prepare additive port. Using aseptic technique and an additive delivery needle of appropriate length, puncture resealable additive port at target area, inner diaphragm and inject. Withdraw needle after injecting medication. The additive port may be protected by covering with an additive cap. Mix container contents thoroughly. Preparation for Administration (Use Aseptic Technique) Close flow control clamp of administration set. Remove cover from outlet port at bottom of container. Insert piercing pin of administration set into port with a twisting motion until the set is firmly seated. NOTE: See full directions on administration set carton. Suspend container from hanger. Squeeze and release drip chamber to establish proper fluid level in chamber. Open flow control clamp and clear air from set. Close clamp. Attach set to venipuncture device. If device is not indwelling, prime and make venipuncture. Regulate rate of administration with flow control clamp. WARNING: Do not use flexible container in series connections. sodium-chloride-injection-1

None known.

Reactions which may occur because of the solution or the technique of administration include febrile response, infection at the site of injection, venous thrombosis or phlebitis extending from the site of injection, extravasation and hypervolemia. If an adverse reaction does occur, discontinue the infusion, evaluate the patient, institute appropriate therapeutic counter measures and save the remainder of the fluid for examination if deemed necessary.