0.25% Acetic Acid Irrigation, Usp

0.25% Acetic Acid Irrigation, Usp
SPL v13
SPL
SPL Set ID 41bc12af-fac5-4ac1-b907-dcb3e35a054c
Route
IRRIGATION
Published
Effective Date 2018-02-02
Document Type 34391-3 HUMAN PRESCRIPTION DRUG LABEL

Drug Facts

Composition & Product

Active Ingredients
Acetic Acid (250 mg)
Inactive Ingredients
Water

Identifiers & Packaging

Marketing Status
NDA Active Since 1982-02-19

Description

0.25% Acetic Acid Irrigation, USP, is a sterile, nonpyrogenic hypotonic solution for irrigation of the urinary bladder. Each 100 mL contains 250 mg Glacial Acetic Acid, USP, (CH 3 COOH) in Water for Injection, USP. pH 3.0 (2.8 to 3.4). Osmolarity: 42 mOsmol/L (calc.). No antimicrobial agent has been added. The container is made from specially formulated polyolefin (PL 325). The polyolefin is a copolymer of ethylene and propylene. It contains no plasticizers or other mobile additives. As a result, the container has virtually no extractability or leachability. The total extractables after two years of storage being less than 0.01 ppm. It is also relatively impermeable to water vapor transmission and, therefore, requires no vapor barrier to maintain the proper drug concentration.

Indications and Usage

0.25% Acetic Acid Irrigation, USP, is indicated as a constant or intermittent bladder rinse to help prevent the growth and proliferation of susceptible urinary pathogens (especially ammonia forming bacteria) in the management of patients who require prolonged placement of an indwelling urethral catheter. It also may be used for periodic irrigation of an indwelling catheter to help maintain patency by reducing the formation of calcium encrustations.

Dosage and Administration

The volume of solution needed will vary with nature and duration of the urologic procedure, according to physician’s instructions. Irrigation drug products should be inspected visually for particulate matter and discoloration prior to administration whenever solution and container permit.

Contraindications

None known

Adverse Reactions

Systemic acidosis, pain and hematuria have been reported in patients receiving urinary bladder irrigation with 0.25% Acetic Acid Irrigation, USP. Should adverse reactions occur, discontinue the irrigation and reevaluate the clinical status of the patient.

How Supplied

0.25% Acetic Acid Irrigation, USP is supplied in a plastic pour bottle as follows: 2F7184 1000 mL NDC 0338-0656-04 Exposure of pharmaceutical products to heat should be minimized. Avoid excessive heat. It is recommended that the product be stored at room temperature (25°C): brief exposure up to 40ºC does not adversely affect the product.


Medication Information

Indications and Usage

0.25% Acetic Acid Irrigation, USP, is indicated as a constant or intermittent bladder rinse to help prevent the growth and proliferation of susceptible urinary pathogens (especially ammonia forming bacteria) in the management of patients who require prolonged placement of an indwelling urethral catheter. It also may be used for periodic irrigation of an indwelling catheter to help maintain patency by reducing the formation of calcium encrustations.

Dosage and Administration

The volume of solution needed will vary with nature and duration of the urologic procedure, according to physician’s instructions.

Irrigation drug products should be inspected visually for particulate matter and discoloration prior to administration whenever solution and container permit.

Contraindications

None known

Adverse Reactions

Systemic acidosis, pain and hematuria have been reported in patients receiving urinary bladder irrigation with 0.25% Acetic Acid Irrigation, USP.

Should adverse reactions occur, discontinue the irrigation and reevaluate the clinical status of the patient.

How Supplied

0.25% Acetic Acid Irrigation, USP is supplied in a plastic pour bottle as follows:

2F7184

1000 mL

NDC 0338-0656-04

Exposure of pharmaceutical products to heat should be minimized. Avoid excessive heat. It is recommended that the product be stored at room temperature (25°C): brief exposure up to 40ºC does not adversely affect the product.

Description

0.25% Acetic Acid Irrigation, USP, is a sterile, nonpyrogenic hypotonic solution for irrigation of the urinary bladder. Each 100 mL contains 250 mg Glacial Acetic Acid, USP, (CH3COOH) in Water for Injection, USP. pH 3.0 (2.8 to 3.4). Osmolarity: 42 mOsmol/L (calc.). No antimicrobial agent has been added.

The container is made from specially formulated polyolefin (PL 325). The polyolefin is a copolymer of ethylene and propylene. It contains no plasticizers or other mobile additives. As a result, the container has virtually no extractability or leachability. The total extractables after two years of storage being less than 0.01 ppm. It is also relatively impermeable to water vapor transmission and, therefore, requires no vapor barrier to maintain the proper drug concentration.

Section 42229-5

Animal reproduction studies have not been conducted with 0.25% Acetic Acid Irrigation, USP. It is also not known whether 0.25% Acetic Acid Irrigation, USP can cause fetal harm when administered to a pregnant woman or can affect reproduction capacity. 0.25% Acetic Acid Irrigation, USP should be given to a pregnant woman only if clearly needed.

Warnings

Not for injection.

Use of this solution in patients with mucosal lesions of the urinary bladder may be harmful due to irritation of the lesion. Absorption via open lesions of the bladder mucosa may result in systemic acidosis.

The contents of an opened container should be used promptly to minimize the possibility of bacterial growth or pyrogen formation. Discard the unused portion of irrigating solution since no antimicrobial agent has been added.

Pediatric Use

Safety and effectiveness in pediatric patients have not been established.

Warm in oven to not more than 50°C for a maximum of 60 days. Discard after 60 days of warming.

Do not administer unless the solution is clear and the seal is intact.

Clinical Pharmacology

The minimal amount of acetic acid which may enter the systemic circulation is readily metabolized.

Package Label Principal Display Panel
Container Label

Not for Injection 2F7184

NDC 0338-0656-04

0.25% Acetic Acid

Irrigation, USP

1000 mL

Each 100 mL contains: 250 mg Glacial Acetic

Acid, USP. No antimicrobial agent has been

added. pH 3.0 (2.8 to 3.4). Osmolarity 42

mOsmol/L (calc.). Sterile, nonpyrogenic. Pour

Bottle. Hypotonic solution for irrigation only.

Dosage and Administration: As directed by a

physician. See directions. Cautions: Warm

in oven to not more than 50°C for a maximum

of 60 days. Discard after 60 days of warming.

Do not use unless solution is clear and seal

is intact. Discard unused portion. Rx only.

Recommended storage: Room temperature

(25°C). Avoid excessive heat. See insert.

PL 325 plastic

Baxter Logo

Baxter Healthcare Corporation


Deerfield, IL 60015 USA

Made in USA

LOT

EXP

07-09-00-0251

FPO

(91)0709000251

Bar Code

Bar Code Posit ion Only*

(01) 00303380656042


Structured Label Content

Section 42229-5 (42229-5)

Animal reproduction studies have not been conducted with 0.25% Acetic Acid Irrigation, USP. It is also not known whether 0.25% Acetic Acid Irrigation, USP can cause fetal harm when administered to a pregnant woman or can affect reproduction capacity. 0.25% Acetic Acid Irrigation, USP should be given to a pregnant woman only if clearly needed.

Warnings (WARNINGS)

Not for injection.

Use of this solution in patients with mucosal lesions of the urinary bladder may be harmful due to irritation of the lesion. Absorption via open lesions of the bladder mucosa may result in systemic acidosis.

The contents of an opened container should be used promptly to minimize the possibility of bacterial growth or pyrogen formation. Discard the unused portion of irrigating solution since no antimicrobial agent has been added.

Description (DESCRIPTION)

0.25% Acetic Acid Irrigation, USP, is a sterile, nonpyrogenic hypotonic solution for irrigation of the urinary bladder. Each 100 mL contains 250 mg Glacial Acetic Acid, USP, (CH3COOH) in Water for Injection, USP. pH 3.0 (2.8 to 3.4). Osmolarity: 42 mOsmol/L (calc.). No antimicrobial agent has been added.

The container is made from specially formulated polyolefin (PL 325). The polyolefin is a copolymer of ethylene and propylene. It contains no plasticizers or other mobile additives. As a result, the container has virtually no extractability or leachability. The total extractables after two years of storage being less than 0.01 ppm. It is also relatively impermeable to water vapor transmission and, therefore, requires no vapor barrier to maintain the proper drug concentration.

How Supplied (HOW SUPPLIED)

0.25% Acetic Acid Irrigation, USP is supplied in a plastic pour bottle as follows:

2F7184

1000 mL

NDC 0338-0656-04

Exposure of pharmaceutical products to heat should be minimized. Avoid excessive heat. It is recommended that the product be stored at room temperature (25°C): brief exposure up to 40ºC does not adversely affect the product.

Pediatric Use

Safety and effectiveness in pediatric patients have not been established.

Warm in oven to not more than 50°C for a maximum of 60 days. Discard after 60 days of warming.

Do not administer unless the solution is clear and the seal is intact.

Adverse Reactions (ADVERSE REACTIONS)

Systemic acidosis, pain and hematuria have been reported in patients receiving urinary bladder irrigation with 0.25% Acetic Acid Irrigation, USP.

Should adverse reactions occur, discontinue the irrigation and reevaluate the clinical status of the patient.

Contraindications (CONTRAINDICATIONS)

None known

Clinical Pharmacology (CLINICAL PHARMACOLOGY)

The minimal amount of acetic acid which may enter the systemic circulation is readily metabolized.

Indications and Usage (INDICATIONS AND USAGE)

0.25% Acetic Acid Irrigation, USP, is indicated as a constant or intermittent bladder rinse to help prevent the growth and proliferation of susceptible urinary pathogens (especially ammonia forming bacteria) in the management of patients who require prolonged placement of an indwelling urethral catheter. It also may be used for periodic irrigation of an indwelling catheter to help maintain patency by reducing the formation of calcium encrustations.

Dosage and Administration (DOSAGE AND ADMINISTRATION)

The volume of solution needed will vary with nature and duration of the urologic procedure, according to physician’s instructions.

Irrigation drug products should be inspected visually for particulate matter and discoloration prior to administration whenever solution and container permit.

Package Label Principal Display Panel (PACKAGE LABEL - PRINCIPAL DISPLAY PANEL)
Container Label

Not for Injection 2F7184

NDC 0338-0656-04

0.25% Acetic Acid

Irrigation, USP

1000 mL

Each 100 mL contains: 250 mg Glacial Acetic

Acid, USP. No antimicrobial agent has been

added. pH 3.0 (2.8 to 3.4). Osmolarity 42

mOsmol/L (calc.). Sterile, nonpyrogenic. Pour

Bottle. Hypotonic solution for irrigation only.

Dosage and Administration: As directed by a

physician. See directions. Cautions: Warm

in oven to not more than 50°C for a maximum

of 60 days. Discard after 60 days of warming.

Do not use unless solution is clear and seal

is intact. Discard unused portion. Rx only.

Recommended storage: Room temperature

(25°C). Avoid excessive heat. See insert.

PL 325 plastic

Baxter Logo

Baxter Healthcare Corporation


Deerfield, IL 60015 USA

Made in USA

LOT

EXP

07-09-00-0251

FPO

(91)0709000251

Bar Code

Bar Code Posit ion Only*

(01) 00303380656042


Advanced Ingredient Data


Raw Label Data

All Sections (JSON)